Format the disk by using DISKPART command
Use DISKPART to format the disk. Try Following the step.
- Check on Disk Management for disk status (This example will using disk 1).
- Open command prompt with run as administrator.
- Enter "diskpart" to open DISKPART.
- Enter "list disk" to list all disks on the computer.
- Select the disk to format by "select disk 1" then disk 1 will be marked to selected.
- "list disk" to re-check for disk 1 was marked.
- Enter "clean" to clean the disk.
- Re-check on Disk Management for this was cleaned.